Cleaning And Descaling - Bartscher PRO Plus 40T Instruction Manual

6.2 Cleaning and descaling

Daily cleaning
o Clean the device after each use.
o After use, wash the device with hot water and a mild, commercially available
detergent for coffee makers. Clean also the filter basket, riser pipe and cover.
Please observe the instructions of the manufacturer.
o Dry these items with a soft cloth.
o The water container should be cleaned of all sediments and coffee remnants.
It can be cleaned with a mild abrasive cleaner and cleaning pan.
o Wipe the surface of the coffee maker with a damp cloth and then dry with a soft cloth.
o To clean the faucet after use, fill the coffee maker with warm water and drain it
through the faucet.
Weekly cleaning
o In the case of everyday use, the entire faucet mechanism must be thoroughly
cleaned every week. With less frequent use, it can be done less frequently.
o To clean the faucet the upper part of the holder should be unscrewed. Clean the
faucet and also the connector between the faucet and the device with the small
brush. Rinse the upper part of the holder and screw it in again.
o The inside of the fill level indicator can be cleaned with the attached brush.
o First remove the fill level indicator cover, pressing it
firmly at the bottom and sliding it up (see the marked
position in the figure on the right), and then remove it.
By loosening the top screw the glass tube can be
removed by pulling it forward. Then remove the
mounting strip from the glass tube.
Insert the attached brush into the top of the
glass tube for cleaning.
After cleaning reassemble the glass tube and
mounting strip.
- 32 -