LifeSize Room 220 Installation Manual page 16

5. Insert the network cable into the network port marked with the LAN symbol
back of the codec. Insert the opposite end of the network cable into a network port on
the wall.
6. Do one of the following:
a. If you are using the LifeSize Phone for audio, insert the phone cable into the port
marked with the LAN symbol
Note: The exterior port marked with the
reserved for future use.
Insert the opposite end of the phone cable into the port marked with the
LifeSize Phone symbol
secured into the guides to avoid damage to them.
Note: When the LifeSize Phone is connected to a LifeSize video communications
system, you are unable to configure it as a standalone speakerphone. Configure
your system using the LifeSize video communications system interface.
b. If you are using a single LifeSize MicPod for audio, insert the end of the cable from
the LifeSize MicPod into the microphone port marked with the microphone symbol
on the back of the codec. If you are using the codec in the upright position with
the stand, LifeSize recommends you route this cable through the strain relief guide
on the stand. If the LifeSize MicPod is installed in an area where the cord could be
pulled or tripped upon, refer to "Attaching the LifeSize MicPod Strain Relief Clip" on
page 22.
Warning:
as permanent damage to the LifeSize MicPod cord connector and the connector in
the codec. LifeSize recommends that you use the cable strain relief clip included in
the LifeSize MicPod product box as described in "Attaching the LifeSize MicPod
Strain Relief Clip" on page 22.
If you are using dual LifeSize MicPods for audio, refer to "Configuring Dual
LifeSize MicPods" on page 21 for a description of supported configuration options.
16
on the back of the codec. Ensure the cables are
Tripping on the LifeSize MicPod cord can cause personal injury as well
on the underside of the phone.
symbol on the LifeSize Phone is
LifeSize Room 220 Installation Guide
on the