Table of Contents
Advertisement
FatTwin F628R3-FT USER'S MANUAL
1-2
Serverboard Features
At the heart of the FatTwin F628R3-FT lies the X10DRFF, a dual processor
serverboard based on the Intel® PCH C612 chipset and designed to provide
maximum performance. Four of these serverboards can be mounted in the
F424AF-R1K28BP chassis.
The sections below cover the main features of the X10DRFF serverboard (see
Figure 1-1 for a block diagram of the chipset).
Processors
The X10DRFF supports single or dual Intel® Xeon® E5-2600v3 series processors
(Socket R3 LGA 2011). Each processor supports four full-width Intel QuickPath
Interconnect (QPI) links, with support of up to 38.4 GT/s per QPI link and with
Data Transfer Rate of up to 9.6 GT/s per direction. Please refer to the serverboard
description pages on our web site for a complete listing of supported processors
(www.supermicro.com).
Memory
Each X10DRFF serverboard node has eight (8) DIMM slots supporting up to 512 GB
LRDIMM registered ECC or 256 GB of DDR4-2133/1866/1600 MHz speed RDIMM
SDRAM in up to 1 GB, 2 GB, 4 GB, 8 GB, 16 GB, 32 GB or 64 GB (LRDIMM only)
size at 1.20Vs voltages. See Chapter 5 for details.
Note: For the latest CPU/memory updates, please refer to our website at
http://www.supermicro.com/products/serverboard.
Serial ATA
A Serial ATA controller is integrated into the PCH C612 to provide up to a ten-port
SATA subsystem, (up to six SATA 3 (6 Gb/s), two SATA 3 SCU and two SATA+Power
connection headers for SATA DOM and power supported by Intel SCU (S-SATA2/3))
which is RAID 0, 1, 5 and 10 supported.
Note: The operating system you use must have RAID support to enable the hot-
swap capability and RAID function of the SATA drives.
PCI Expansion Slots
The FatTwin F628R3-FT has for each node 1x PCI-E 3.0 x16 low-profi le slot
available for use with a riser card.
1-2
Advertisement
Table of Contents
