Restore Factory Settings; Installation Instructions Wi-Fi Operation - Abus PPIC46520 Instruction Manual

Hide thumbs Also See for PPIC46520:

Table of Contents

5. Restore factory settings

When installing the camera, make sure that it is within optimal range of the router. The camera can

only be accessed if there is a sufficient Wi-Fi signal to the router.

For installations in larger objects, a Wi-Fi repeater is recommended to optimize the range. Optionally,

you can also operate the camera via LAN.

Please note that structural conditions can influence the transmission.

Note

Information about compatible Wi-Fi repeaters can be obtained from your network operator

or the manufacturer of your router. ABUS Security Center GmbH & Co. KG will not make

any recommendations for Wi-Fi repeaters.

Pay close attention to the installation recommendations of the Wi-Fi repeater. The

positioning should ideally be between the router and the camera.

If there are any difficulties during setup or if you have

forgotten the access data (admin password and/or

security code), reset the camera to factory settings:

Open the bottom cover of the camera using an Allen

key and press the reset button using a thin object (e.g.

the microSD card removal tool or a paper clip) for at

least 5 seconds until the status LED flashes.

English

Table of Contents