Replacing The Presser Foot - Brother NQ3700D Operation Manual

Replacing the Presser Foot

CAUTION
• Use the appropriate presser foot for the type
of stitch that you wish to sew, otherwise the
needle may hit the presser foot, causing the
needle to bend or break. For details on the
presser foot that should be used with the
selected stitch, refer to "Stitch Chart" on
page 45.
• Use presser feet designed specifically for this
machine.
Note
• When a stitch is selected, the icon for the presser
foot that should be used appears in the screen.
Check that the correct presser foot is attached
before starting to sew. If the wrong presser foot is
installed, attach the appropriate presser foot.
(page 13)
Replacing the presser foot
a Press (Needle position button) once or twice to
raise the needle.
b Press .
• When the message [OK to automatically lower the
presser foot?] appears on the LCD screen, press
to continue.
 The screen changes, and all keys and operation
buttons are locked (except
CAUTION
• When replacing the presser foot, be sure that
you have pressed
to lock all keys and buttons, otherwise injuries
may occur if the "Start/Stop" button or any
other button is pressed and the machine starts.
).
on the operation panel
c Raise the presser foot lever.
d Press the black button at the back of the presser foot
holder in order to remove the presser foot.
a
Place the appropriate presser foot below the presser
e
foot holder so that the presser foot pin is aligned with
the notch in the holder.
1
4
2
J
3
f Slowly lower the presser foot lever so that the presser
foot pin snaps into the notch in the presser foot holder.
a
1 Presser foot lever
2 Presser foot holder
3 Notch
4 Pin
 The presser foot is attached.
g Raise the presser foot lever to check that the presser
foot is securely attached.
h Press to unlock all keys and buttons.
Replacing the Presser Foot
1 Black button
2 Presser foot holder
1 Presser foot holder
2 Notch
3 Pin
4 Presser foot type
c
29
1