Table of Contents
Advertisement
ADVANCED CONTROL
REQUIREMENT
NOTES:
S Powering on the unit and interface for the first time, it
takes time for the remote control to recognize the
operation input. This is not a malfunction.
S For details on auto address setting of units when
operating together with VRF system (adjust auto
address setting on circuit board of outdoor interface).
S Turn on the indoor unit first. Refer to the installation
manual of the unit about its power supply.
S When shipped from the factory, all of the setting are set
to [ Factory default ]. Change the setting using the main
remote control (wired remote control).
S The settings cannot be changed using the wireless
remote control, the sub remote control, or a system
without a remote control (system with only the central
remote control). Therefore, prepare the main remote
control and install.
Functional setting by DN code
Changing of settings for applicable controls
(DN code setting)
Basic procedure for changing settings
Change the settings while the unit is not working.
(Be sure to stop the unit before making settings).
Fig. 62 - Field Settings Menu
Procedure 1
1. Push the [
MENU ] button.
2. Push the [
MENU ] / [
simultaneously for more than 4 seconds.
3. Push the [
] / [
DN setting" on the "Field setting menu" screen.
4. Then push the [
F2] button.
5. Move the cursor to select "DN code" with the "<"
[F1] button.
6. Set "DN code" with [
7. Move the cursor to select "data" with the [
button, then set "data" with the [
[
] button.
Fig. 63 - DN Setting
Procedure 2
Refer to this installation manual for details about the DN
code and data.
Fig. 64 - DN Code and Data
Procedure 3
1. Push [
MENU ] button to set other DN codes.
2. After "Continue?" is displayed on the screen, push
the "Yes" [
F1 ] button.
Procedure 4
1. Push "No" [
F2] button to finish setting operation.
2.
appears on the screen for a while.
3. The screen returns to the "Field setting menu" screen.
39
] button
] button to select "7.
] / [
] buttons.
F2]
] /
Advertisement
Table of Contents
