Panasonic SE4D Series Instruction Manual page 24

<In case of using dead zoneless mounting bracket (SE9Z-SED-3) (optional)>
1. Set the spacer attached to the dead zoneless mounting bracket (SE9Z-SED-3) onto the
mounting hole on the side of the top (bottom) end part of this device, and insert the hexa-
gon-socket head bolt [M5 (length: 25mm)] into the hole.
<In case of rear mounting>
Spacer
(Enclosed with SE9Z-SED-3)
Main body
2. Adjust the hexagon-socket head bolt with the status described in Step 1 to the mounting
hole of the dead zoneless mounting bracket, and tighten and fix the bracket.
The tightening torque should be 1.2N·m or less.
<In case of rear mounting>
Main body
3. Set the dead zoneless mounting bracket that is ready for setting to the mounting surface us-
ing four hexagon-socket head bolts [M5 (purchase separately)].
<In case of rear mounting>
Hexagon-socket head bolt
[M5 (purchase separately)]
Note: For the models that the intermediate supporting bracket (SE9Z-SED-2) is enclosed with, be sure to use the
intermediate supporting bracket (SE9Z-SED-2). For details, refer to <In case of using intermediate sup-
porting bracket (SE9Z-SED-2) (accessory)>.
23
Hexagon-socket head bolt
[M5 (length: 25mm)]
(Enclosed with SE9Z-SED-3)
Dead zoneless mounting bracket
(SE9Z-SED-3) (Optional)
Dead zoneless moun ing bracket
(SE9Z-SED-3) (Optional)
Hexagon-socket head bolt
[M5 (Purchase separately)]
Main body
<In case of side mounting>
Main body
<In case of side mounting>
Dead zoneless mounting bracket
(SE9Z-SED-3) (Optional)
Main body
<In case of side mounting>
Spacer
(Enclosed with SE9Z-SED-3)
Dead zoneless mounting bracket
(SE9Z-SED-3) (Optional)
Main body