Panasonic SE4D Series Instruction Manual page 31

<In case of using I/O circuit for NPN output>
Connector pin No.
Emitter
0.22μF
470Ω
0.22μF
470Ω
0.22μF
470Ω
Internal circuit
Receiver
0.22μF
470Ω
0.047μF
1kΩ
0.047μF
1kΩ
Internal circuit
*S1
Switch S1
● Emission halt input / Reset input
For manual reset: 0 to +1.5V (source current 5mA or less): Emission halt, Open: Emission
For auto-reset: 0 to +1.5V (source current 5mA or less): Emission, Open: Emission halt
● Interlock setting input, Override input, Muting input A / B, External device monitor input
0 to + 1.5V (source current: 5mA or less): Valid, Open: Invalid
Note: The circuit diagram shown above is for 12-core cable to be used. For 8-core cable, red, yellow, gray, gray /
black, sky-blue / white, sky-blue / black, there is no lead wire.
<Reference>
K1, K2: External device (Forced guided relay or magnetic contactor)
Color code
(Brown) +V
(Shield) Output polarity setting wire
(Yellow) Override input
(Pale purple) Interlock setting input
(Pink) Emission halt input / Reset input
(Gray) Interference prevention +
(Gray / Black) Interference prevention -
(Yellow-green / Black) Auxiliary output
(Red) Muting lamp output
(Blue) 0V
(Orange) Synchronization +
(Orange / black) Synchronization -
Users' circuit
(Orange / Black) Synchronization -
(Orange) Synchronization +
(Brown) +V
(Shield) Output polarity setting wire
(Black) Control output 1 (OSSD 1)
(White) Control output 2 (OSSD 2)
(Gray) Interference prevention +
(Gray / Black) Interference prevention -
(Yellow-green) External device monitor input
(Sky-bule / White) Muting input A
(Sky-bule / Black) Muting input B
(Blue) 0V
Users' circuit
Load
*S1 *S1 *S1
K1
K1
*S1
*S1 K2
+
24V DC
±10%
-
K2
30