Wiring Configuration For Valid Muting Function - Panasonic SE4D Series Instruction Manual

2-5-11 Wiring Configuration for Valid Muting Function

(Wiring Example of the Control Category 4)
<For PNP output>
Gray cable
Gray cable
with black line
Interlock function
External device monitor function Valid
Auxiliary output
The device output is selected depending on the connecting state of the output polarity setting wire
(shield). Incorrect wiring may cause the lockout state.
* Symbols
Switch S1
Vs to Vs - 2.5V (sink current 5mA or less): Emission (Note 2), Open: Emission halt
Switch S2
The muting input, the override input
Vs to Vs - 2.5V (sink current 5mA or less): Valid (Note 2), Open: Invalid
K1, K2: External device ( Forced guided relay or magnetic contactor)
Notes: 1) The incandescent lamp with 3 to 10W shall be connected to the muting lamp output. If the muting lamp is
not connected, the muting function does not operate.
2) Vs is the applying supply voltage.
(Gray) Interference prevention +
(Gray / Black) Interference prevention -
(Pale purple) Interlock setting input
(Brown) +V
(Red) Muting lamp output
(Pink) Emission halt input / Reset input
(Yellow) Override input
(Yellow-green / Black) Auxiliary output
(Shield) Output polarity setting wire
(Blue) 0V
(Orange) Synchronization +
(Orange / Black) Synchronization -
(Orange / Black) Synchronization -
(Orange) Synchronization +
(Yellow-green) External device monitor input
(Brown) +V
(Sky-bule / White) Muting input A
(Sky-bule / Black) Muting input B
(Black) Control output 1 (OSSD 1)
(White) Control output 2 (OSSD 2)
(Shield) Output polarity setting wire
(Blue) 0V
(Gray / Black) Interference prevention -
(Gray) Interference prevention +
Invalid (Auto-reset)
Can be used
*S1
(Note 1)
Load
K1
*S2
K1
K2
*S2
+
24V DC
±10 %
-
K2
*S2
52