Failure Identification Procedure; Notes On Using The Fault Code Tables - Benchmark ZWB 7-29 CC1 Installation And Servicing

Table of Contents

Advertisement

3

Failure identification procedure

3.1
Notes on using the fault code
tables
The procedure is best described with the aid of
an example:
• Work through the table from top to bottom and from
left to right.
• First make a note of the present settings and restore
them before leaving the appliance.
• Read question 1. (Check column)and depending on
the answer (yes or no) read the action required from
the relevant box and carry out the instruction given;
ignore the other answer. For example: if the burner
flame is visible, follow the instructions for yes, i.e.
↓5.!
• ↓5. means go to number 5., ignoring the steps in
between.
EA
and
Flame not detected
Check
1.
Is a burner flame visible?
2.
Is the gas cock turned on?
3.
Has the thermal cut-out on the gas
cock tripped?
4. ...
...
5. ...
Problem with flue?
B Check CO
level in combustion
2
air.
Is CO
level above 0,2 % ?
2
Table 7
7 181 465 346 GB (03.02)
flashing.
yes:
no:
yes:
no:
yes:
no:
yes:
no:
Failure identification procedure
In this example: check the flue is clear by testing
the CO
level.
2
• If the appliance is locked (
press the
button. Important: after unlocking the
appliance, always restart it (i.e. switch off and then
on again). Only then is it possible to say whether or
not the fault has been eliminated.
• If the fault has been rectified, the appliance will then
start up without indicating a fault and the fault isola-
tion procedure is complete.
• If the fault is still present after performing the action
specified and, if necessary, restarting the appliance,
move on to the next step in the fault isolation proce-
dure.
• If another fault code is displayed, work through the
fault code table for that code.
Action
B Note the setting of the temperature controls
and
.
↓ 5.
↓ 2.
↓ 5.
B Open the gas cock.
B Press
, restart the appliance.
EA? ↓3.
...
↓ ...
Check flue.
↓ ...
Return to normal operation:
B Press the button
on the display.
B Regulate the temperature control
temperature control
positions.
button is flashing),
until the symbol [ ] appears
and the
on the previously set
13

Advertisement

Table of Contents
loading

This manual is also suitable for:

47 108 05

Table of Contents