AC
flashing.
Module not detected.
(Constant CH flow temperature according to CH temperature control on boiler.)
Check
7.
Remote control status still 0.?
8.
The PCB control board is damaged.
7 181 465 346 GB (03.02)
Action
B Power OFF the appliance.
yes:
Remote control:
B Replace top section.
B Turn ON the appliance.
AC? ↓8.
↓8.
no:
B Make a note of the altered service settings (see
table 1, "First Service Level; Values that can be
modified" at page 8 and table 5, "Secondary
Service Level; Values that can be modified" at
page 11).
B Power OFF the appliance.
B Disconnect the boiler electrical connection.
B Change PCB control board.
B Reconnect the boiler electrical connection.
B Turn ON the appliance.
B Restore service settings previously noted down.
To return to normal function mode:
B Press buttons
B Regulate the temperature control
temperature control
positions.
Failure identification procedure
and
simultaneously.
and the
on the previously set
21