1. Manuals
  2. Brands
  3. Benchmark Manuals
  4. Boiler
  5. i-mini 24
  6. User manual

Benchmark i-mini 24 User Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

USERS GUIDE

24, 30
For installation guide see reverse of book
When replacing any part on this appliance, use only spare parts that you can be
assured conform to the safety and performance specification that we require.
Do not use reconditioned or copy parts that have not been clearly authorised by Ideal.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the i-mini 24 and is the answer not in the manual?

Questions and answers

steve
January 26, 2025

hi there can you range rate an i mini boiler

0

Related Manuals for Benchmark i-mini 24

Summary of Contents for Benchmark i-mini 24

  • Page 1: Users Guide

    USERS GUIDE 24, 30 For installation guide see reverse of book When replacing any part on this appliance, use only spare parts that you can be assured conform to the safety and performance specification that we require. Do not use reconditioned or copy parts that have not been clearly authorised by Ideal.

  • Page 2: Electricity Supply

    All Gas Safe Register installers carry a Gas Safe Register ID card, and have a registration number. Both should be recorded in the Benchmark Commissioning Checklist. You can check your installer by calling Gas Safe Register direct on 0800 4085500.

  • Page 3: Operation

    operation Due to system variations and seasonal temperature fluctuations DHW flow rates/temperature rise will vary, requiring adjustment Winter conditions - i.e. Ch and DhW required. at the draw off tap : the lower the rate the higher the temperature, Ensure the mode knob control (D) is set to winter ( and vice versa.

  • Page 4: Loss Of System Water Pressure

    Loss of system water pressure Condensate Drain The gauge (G) indicates the central heating system pressure. If This appliance is fitted with a siphonic condensate trap the pressure is seen to fall below the original installation pressure system that reduces the risk of the appliance condensate of 1-2 bar over a period of time then a water leak may be from freezing.

  • Page 5: Troubleshooting

    pOINTs FOR ThE BOILER UsER Note. In line with our current warranty policy we would ask that you check through the Troubleshooting guide to identify any problems external to the boiler prior to requesting a service engineers visit. Should the problem be found to be other than with the appliance we reserve the right to levy a charge for the visit, or for any pre-arranged visit where access is not gained by the engineer.

  • Page 6: Operation Modes

    OpERaTION MODEs DEsCRIpTION DIspLay CODE ON BOILER The boiler is in standby mode awaiting either a central heating call or hot water demand. The boiler has a call for central heating but the appliance has reached the desired temperature set on the boiler. The boiler has a call for hot water but the appliance has reached the desired temperature set on the boiler.

  • Page 7: Fault Codes

    FaULT CODEs DEsCRIpTION aCTION DIspLay CODE ON BOILER Outside Sensor Failure Reset the appliance - if the boiler fails to operate then please contact Ideal (if under warranty) or alternatively a Gas Safe Registered Engineer if outside of the warranty period. In IE contact a Registered Gas Installer (RGII).
  • Page 8 i-mini - User’s...

This manual is also suitable for:

I-mini 30

Table of Contents