Illumination Beam Director; Vertical Height Adjustment Ring (Vertical Colposcope Model Only); Swing Arm Height Adjustment (Swing Arm Colposcope Model Only); Positioning Video Colposcope - Welch Allyn 88000A Operating Instructions Manual

Illumination Beam Director

The illumination beam director can be rotated up to 45° clockwise or counterclockwise to better illuminate the examination
area. To rotate the director, grasp the flat sides and twist in either direction as desired. The illumination beam director moves
with some resistance. This helps to hold it securely in the desired position. The center position can be recovered by returning
the director to the detent position.
Vertical Height Adjustment Ring
The height of the vertical stand can be adjusted by rotating the black height adjustment ring, located on the pole of the stand,
counterclockwise. Once the ring has been loosened, adjust the pole to the desired height and then tighten the ring again by
rotating it clockwise.
Swing Arm Height Adjustment
Adjust the height of the swing arm stand by loosening the height adjustment knob located on the arm of the stand. The swing
arm can then be moved to the desired position. After moving the arm, tighten knob securely by rotating clockwise. The desired
drag can be obtained by adjusting this knob either clockwise or counterclockwise.

Positioning Video Colposcope

The video colposcope can be angled up and down and left and right. To change the up/down tilt angle, loosen the knob located
on the tilt axis. The video colposcope can then be tilted as necessary. To change the horizontal angle, loosen the knob located
on the support shaft. The drag of either knob can be set by loosening or tightening as necessary.

Remote Video Functions

The handle of the video colposcope contains three buttons that control three video functions. These functions, provided by a
remote video printer, are Freeze, Print, and Toggle. (See "Connection Diagrams" on page 11. of this manual for connecting the
printer to the video colposcope.)
1. Pressing the freeze ("F") button stores a new image in printer memory. The frozen image is displayed on the monitor.
2. Pressing the copy ("C") button prints the image displayed on the monitor. If live video is displayed, the image visible
when the button was pressed will be printed.
3. Pressing the video ("V") button changes the display from printer memory (frozen image) to live video, or from live video to
printer memory (frozen image), depending on the current mode.
(Vertical Colposcope Model Only)
(Swing Arm Colposcope Model Only)
16