Swing Arm Stand Assembly - Welch Allyn 88000A Operating Instructions Manual

4. Place pole into the base, aligning the pin on the flange with the pin hole in the base. Place bolt, spacer, and washer, ori-
ented as shown, into the pole. Tighten securely with the enclosed Allen wrench. (The assembly may need to be tilted.)
Washer
Spacer
Hex Bolt
Allen Wrench
5. Before using the video colposcope, refer to "Setting Up Video Colposcope" section of this manual.

Swing Arm Stand Assembly

The video colposcope stand is shipped unassembled. Minimal assembly is required.
NOTE: BASE WEIGHS 58 LBS. YOU MAY REQUIRE ASSISTANCE TO LIFT IT.
1. To assemble the stand, remove the stand and base parts from the
cartons.
2. Place base upside down on the floor and insert casters into holes on
the bottom of the base. (Do not place two locking casters next to
each other.)
3. Place the base on the floor with casters down. Lock the two locking
casters.
4. Place the vertical pole section of
the assembly into the base, aligning
the pin on the flange with the pin
hole in the base.
5. Locate the packaged bolt.
6. Place the bolt through the bottom of
the pole. (The assembly may need
to be tilted.)
7. Tighten securely with the enclosed
Allen wrench.
8. Remove the bolt from the arm of the colposcope assembly and insert it through the hole near the top of the pole.
9. Position the pole and the arm of the remaining colposcope assembly in close proximity.
Hex Bolt
Allen Wrench
10. Connect the two wire harnesses via their connectors. (This may
require assistance for proper assembly.)
13
Align pin with hole
Locking caster
Align pin with hole