Removing the Power-Connector Port
1.
Follow the procedures in
2.
Remove the:
a.
base cover
b.
battery
c.
display assembly
3.
Perform the following steps:
a. Disconnect the power-connector port cable from its connector on the system board [1].
b. Remove the power-connector port from the computer [2].
Installing the Power-Connector Port
1.
Insert the power-connector port into its place on the computer.
2.
Connect the power-connector port cable to its connector on the system board.
3.
Install the:
a.
display assembly
b.
battery
c.
base cover
4.
Follow the procedures in
Removing the Hard-Drive Assembly
1.
Follow the procedures in
2.
Remove the:
a.
base cover
b.
battery
Before Working Inside Your
After Working Inside Your
Before Working Inside Your
Computer.
Computer.
Computer.
19