Danfoss Metasys N2 Operating Instructions Manual page 8

Instructions
2.1.8 Analog Input Commands (Not Acknowledged)
VLT Comm and Region NPA Object no.
Response
NAK 1 1
NAK 1 1
NAK 2 -
NAK 2 -
NAK 2 -
NAK 2 -
NAK 2 -
NAK 2 -
NAK 2 -
NAK 2 -
1)
Error code 11 is used because attributes are considered as fields/records in the point map database.
®
VLT Metasys
Attribute Attribute Message Type
No.
0-23 4 Float
0-23 5 Float
0-23 2 Byte
0-23 3 Float
0-23 4 Float
0-23 5 Float
0-23 6 Float
0-23 7 Float
0-23 13 Integer
0-23 14 Float
®
MG.11.G2.02 - VLT is a registered Danfoss trademark
Error
Code
Read Analog 1 ) Read Linear Ranging Parameter 1
11
Input attribute associated with each
individual point. (JCI use only)
Read Analog Read Linear Ranging Parameter 2
11 1)
Input attribute associated with each
individual point. (JCI use only)
Write Analog 1) Object Status writeable
11
Input
Write Analog Analog Input Value not writeable
11 1)
Input
Write Analog 1) Write to Linear Ranging Parame-
11
Input ter 1 attribute associated with
each individual point. (JCI use
Write Analog Write to Linear Ranging Parame-
11 1)
Input ter 2 attribute associated with
each individual point. (JCI use
Write Analog 1) Write to Linear Ranging Parame-
11
Input ter 3 attribute associated with
each individual point. (JCI use
Write Analog 1) Write to Linear Ranging Parame-
11
Input ter 4 attribute associated with
each individual point. (JCI use
Write Analog 1) Write to Filter Weight attribute
11
Input associated with each individual
Write Analog Write to AI Offset attribute associ-
11 1)
Input ated with each individual point.
Comments
only)
only)
only)
only)
point. (JCI use only)
(JCI use only)
7
2 2