Danfoss Metasys N2 Operating Instructions Manual page 7

Instructions
2.1.7 Analog Input Commands (Acknowledged)
2 2
VLT
Response
ACK
ACK
ACK
ACK
ACK
ACK
ACK
ACK
ACK
ACK
ACK
ACK
ACK
ACK
ACK, no
action
ACK, no
action
ACK, no
action
6
Command Subcom-
Region
mand
1 - 1
1 - 1
1 - 1
1 - 1
1 - 1
1 - 1
1 - 1
1 - 1
2 - 1
2 - 1
2 - 1
2 - 1
2 - 1
2 - 1
7 2 1
7 3 1
7 7 1
MG.11.G2.02 - VLT
®
VLT Metasys
NPA Object Attribute
Attribute Message Type
no. No.
0-23 1 Byte
0-23 2 Byte
0-23 3 Float
0-23 8 Float
0-23 9 Float
0-23 10 Float
0-23 11 Float
0-23 12 Float
0-23 1 Byte
0-23 8 Float
0-23 9 Float
0-23 10 Float
0-23 11 Float
0-23 12 Float
0-23 - Float
0-23 - -
0-23 - -
®
is a registered Danfoss trademark
Comments
Read Analog Read Object Configuration attribute
Input associated with each individual point
1)
Read Analog Read Object Status attribute
Input associated with each individual point
Read Analog 2) Read Analog Input Value attribute
Input
associated with each individual point
Read Analog Read Low Alarm attribute associated
Input with each individual point
Read Analog Read Low Warning attribute associ-
Input ated with each individual point
Read Analog Read High Warning attribute associ-
Input ated with each individual point
Read Analog Read High Alarm attribute associated
Input with each individual point
Read Analog Read Differential attribute associated
Input with each individual point
Write to Object Configuration attrib-
Write Analog
ute associated with each individual
Input
point
Write Analog Write to Low Alarm Limit attribute
Input associated with each individual point
Write Analog Write to Low Warning Limit attribute
Input associated with each individual point
Write Analog Write to High Warning Limitattribute
Input associated with each individual point
Write Analog Write to High Alarm Limit attribute
Input associated with each individual point
Write Analog Write to Differential attribute associ-
Input ated with each individual point
Analog inputs are "outputs" from the
Override frequency converter and should not
Analog inputs be written over by the network
controller
Analog inputs are "outputs" from the
Override frequency converter and should not
Analog Release be written over by the network
controller
Write Analog Optional command for slave devices.
Input Attrib- Only used for N2
utes commissioning purposes