Danfoss Metasys N2 Operating Instructions Manual page 10

Instructions
2.1.10 Analog Output Commands (Not Acknowledged)
VLT Command Region
Response
0-2 1 3
NAK 1 3
NAK 2 3
NAK 2 3
NAK 2 3
NAK 2 3
1)
Error code 11 is used because attributes are considered as fields/records in the point map database.
®
VLT Metasys
NPA Object Attribute Attribute Message Type
no. No.
0-2 4 Float
0-2 5 Float
0-2 2 Byte
0-2 3 Float
0-2 4 Float
0-2 5 Float
®
MG.11.G2.02 - VLT is a registered Danfoss trademark
Error
Code
Read Analog 1 Read Low Linear Ranging
11
Output Parameter attribute associated
with each individual point. (JCI
Read Analog Read High Linear Ranging Para-
11 1
Output meter attribute associated with
each individual point. (JCI use
Write Analog 1 Object Status not writeable
11
Output
Write Analog 1 Write to Current Value structure
11
Output attributes associated with each
individual point. (N2 does not
support this, override function
Write Analog Write Debouncing Value in msec
11 1
Output attribute associated with each
individual point.(JCI use only)
Write Analog 1 Write Accumulator value attrib-
11
Output ute associated with each individ-
ual point. (JCI use only)
2
Comments
use only)
only)
must be used)
9
2