Danfoss Metasys N2 Operating Instructions Manual page 13

Instructions
2.1.14 Binary Output (BO) Commands (Not Acknowledged)
2 2
VLT
Response
NAK
NAK
NAK
NAK
NAK
2.1.15 Internal Integers (ADI) Commands (Acknowledged)
VLT
Response
ACK
ACK
ACK
ACK
ACK
12
Command Region NPA Object
no.
1 4 0-10
1 4 0-10
2 4 0-10
2 4 0-10
2 4 0-10
1) Error code 11 is used because attributes are considered as fields/records in the point map database.
Command Subcom- Region NPA Object no. Attribute No.
mand
1 - 6
1 - 6
2 - 6
7 2 6
7 3 6
MG.11.G2.02 - VLT
®
VLT Metasys
Attribute No. Attribute Message Type Error Code
6 Integer Read Binary
7 Integer Read Binary
2 Byte Write Binary
6 Integer Write Binary
7 Integer Write Binary
0-254 1
0-254 2
0-254 -
0-254 -
0-254 -
®
is a registered Danfoss trademark
1) Read Interstage on delay attrib-
11
Output ute associated with each
individual point. (JCI use only)
Read Interstage off delay attrib-
11 1)
Output ute associated with each
individual point. (JCI use only)
1) Object Status not writeable
11
Output
Write Interstage on delay attrib-
11 1)
Output ute associated with each
individual point. (JCI use only)
1) Write Interstage off delay attrib-
11
Output ute associated with each
individual point. (JCI use only)
Attribute Message Type
Integer Read Internal Read Object Status associ-
Parameter of ated with each individual
object type
integer (16 bit)
Integer Read Internal Read Current Value attrib-
Parameter of ute associated with each
object type
integer (16bit)
Integer Write Internal Write to Current Value
Parameter of attribute associated with
object type
integer (16bit)
Integer Override Internal Write to internal parame-
Parameter of ter current value (set-up
object type
Integer (16 bit)
- Override Release Set the current value, the
value that it was before
the 1. Override Command
Comments
Comments
point
individual point
each individual point
parameters for VLT)
was issued