Tiger JBX-A10W Operating Instructions Manual page 35

Removing and attaching the steam cap
„ Removing the steam cap
(1) Insert your fingers into the indentation in
the lid and lift and remove the steam cap.
Note
● Be careful when removing the steam cap
immediately after cooking, as hot condensation is
collected in it.
(2) Rotate the cap unit counterclockwise
to align the marking on the cap with the
unlock symbol
.
The unlock symbol is marked on the cap lid.
Cap lid
Cap unit
Turn the cap unit
until it stops.
Marking
„ Attaching the steam cap
(1) Align the protrusions of the cap unit with the
indentations of the cap lid as shown in the
figure and fit the cap unit into the cap lid.
There are three indentations and protrusions each.
(3) Lift and remove the cap unit from the cap lid.
Steam cap
Note
● Do not remove the gasket or O-ring from the cap
unit. Securely reattach the gasket or O-ring if it
comes off. Make sure that the direction of the
gasket on the cap unit is correct.
Wet the O-ring if it is difficult to attach it.
● Be sure to set the gaskets, etc. before using the rice
cooker. Failure to do so may allow steam to leak out
and prevent the food from cooking properly.
Unlock symbol
(2) Rotate the cap unit clockwise and align the
marking on the cap unit with the lock symbol.
The lock symbol is marked on the cap lid.
(3) Securely attach it to the rice cooker.
Gasket
Cap unit
Cap lid
O-ring
Turn the cap unit
until it stops.
Marking
Lock symbol
35 35 35