Operation - Hilti SIW 22-A Original Operating Instructions

5.6 Installing an accessory tool
SIW 14­A
SIW 22­A
1. Check that the connection end of the accessory tool is clean.
▶ If necessary, clean the connection end.
2. Set the forward/reverse switch to the middle position or remove the
battery from the power tool.
3. Bring the notch in the accessory tool into alignment with the ball on the
square drive.
4. Push the accessory tool onto the square drive until it engages.
5. Before using the power tool, check that the accessory tool is correctly
seated and secure.
6

Operation

Observe the safety instructions and warnings in this documentation and on
the product.
6.1 Setting the torque
▶ Repeatedly press the torque selector switch until the desired torque
setting is indicated by the indicator on the left beside the switch.
SID 14­A
SID 22­A
Model SID ... → page 10
SIW 14­A
SIW 22­A
Model SIW ... → page 10
6.2 Setting forward or reverse rotation
An interlock prevents switching while the motor is running.
The control switch is locked when the forward/reverse switch is in the
middle position (safety lock).
▶ Set the forward/reverse switch to the desired direction of rotation.
6.3 Switching on
▶ Press the control switch.
▶ Speed of rotation is regulated by the distance the control switch is
pressed in.
*2153700*
4
5
2153700
6
English 13