Table of Contents
Advertisement
Before You Begin
Safety Notes
Read all the following safety notes before working with this product. These notes contain important
information about the installation, usage, and maintenance of this product.
This product contains no user-serviceable parts. Any reference to servicing in this User
Manual will only apply to properly trained, certified technicians. Do not open the housing
or attempt any repairs.
All applicable local codes and regulations apply to proper installation of this product.
•
The luminaire is intended for professional use only.
•
The luminaire should be positioned so that prolonged staring into the luminaire at a distance closer than
15.4 ft (4.7 m) is not expected.
•
If the external flexible cable or cord of this luminaire is damaged, it shall be replaced by a special cord
or cord exclusively available from the manufacturer or its service agent.
•
The light source contained in this luminaire shall only be replaced by the manufacturer or its service
agent or a similar qualified person.
•
CAUTION:
•
This product's housing may be hot when operating. Mount this product in a location with adequate
ventilation, at least 20 in (50 cm) from adjacent surfaces.
•
When transferring the product from extreme temperature environments, (e.g., cold truck to warm humid
ballroom) condensation may form on the internal electronics of the product. To avoid causing a failure,
allow the product to fully acclimate to the surrounding environment before connecting it to power.
•
Flashing light is known to trigger epileptic seizures. User must comply with local laws regarding
notification of strobe use.
•
ALWAYS:
•
Disconnect from power before cleaning the product or replacing the fuse.
•
Replace the fuse with the same type and rating.
•
Use a safety cable when mounting this product overhead.
•
Connect this product to a grounded and protected circuit.
•
DO NOT:
•
Open this product. It contains no user-serviceable parts.
•
Look at the light source when the product is on.
•
Leave any flammable material within 20 cm of this product while operating or connected to power.
•
Connect this product to a dimmer or rheostat.
•
Operate this product if the housing, lenses, or cables appear damaged.
•
Operate this product outdoors or in any location where dust, excessive heat, water, or humidity may
affect it (adhere to standards for the published IP rating).
•
ONLY use the handles or the hanging/mounting brackets to carry this product.
•
The maximum ambient temperature is 113 °F (45 °C). Do not operate this product at higher temperatures.
•
The minimum startup temperature is -4°F (-20°C). Do not start the product at lower temperatures.
•
The minimum ambient temperature is -22°F (-30°C). Do not operate the product at lower temperatures.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
•
In the event of a serious operating problem, stop using immediately.
If a Chauvet product requires service, contact Chauvet Technical Support.
Maverick Force 3 Profile User Manual Rev. 1
3
Advertisement
Table of Contents
