Biamp NPS-1 Quick Start Manual

Manually accessing a Network Paging Station's

settings (NPS-1)

When attempting to configure or troubleshoot the NPS-1 it may be necessary to access the NPS-1

settings when not using the Audia software, this can be done via a button press detailed in the manual.

Setup can be performed regardless if the paging station is connected to a functional Audia FLEX system or not.

http://support.biamp.com/

Table of Contents

Need help?

Do you have a question about the NPS-1 and is the answer not in the manual?

Page 1 Manually accessing a Network Paging Station's settings (NPS-1) When attempting to configure or troubleshoot the NPS-1 it may be necessary to access the NPS-1 settings when not using the Audia software, this can be done via a button press detailed in the manual.
Page 2 1. To enter setup, turn the Scroll Wheel while holding down all three buttons (Cancel, Enter, & Push-To-Talk). An icon in the lower-left corner of the LCD panel indicates that pressing the Cancel button will return the unit to normal operation. Copyright 2013-2020 Biamp Systems http://support.biamp.com/...
Page 3 CobraNet discovery and settings The NPS-1 must be on the CobraNet side of the network and within the same subnet as the CobraNet port for proper communication. Typically leaving it as DHCP is fine as long as it is a unique subnet from the Control port.