Table of Contents
Advertisement
To program the LED brightness:
1. If the display is to be used inside the coach, the LED brightness
should be low. If it is to be used in the service bay area where
sunlight can reach it, the LED brightness should be high.
2. To program the LED brightness, the display needs to enter
the brightness programming mode. To do this, press and
hold down the BATT button, the display will show the battery
voltage.
3. While continuing to hold down the BATT button, press and
hold down the GREY button. Continue to hold down both
buttons for about 5 seconds until the display shows "bri"
to indicate the brightness programming mode. When this
occurs release both buttons.
4. The display will now indicate the brightness that is currently
programmed by showing "b-1", "b-2", "b-3", or "b-4", where
"b-1" is the minimum brightness and "b-4" is the maximum
brightness.
5. Press the GREY tank button to increase brightness, or the
FRESH tank button to decrease brightness.
6. When the display shows the correct brightness, press the
BATT button to exit the programming mode.
To program the number of senders for each tank:
1. To program the number of senders for each tank, the display
needs to enter the sender programming mode. This should
only be done at the time of installation; there is no reason
to change the number of senders afterward. Make sure that
the number of senders programmed into the display matches
with the number of senders connected; otherwise the display
will show an error.
2. To enter the sender programing mode, press and hold the
button for the tank to be programmed, the display may show
a level or an error message for that tank.
3. While continuing to hold down the button for the tank, press
and hold the BATT button. The display will immediately show
"dIA" (diagnostics), continue to hold down both buttons until
the display enters the programming mode, this should take
about 10 seconds.
4. When the programming mode is entered, the display will
show "FrS" if entering the number of senders for the fresh
tank, "GrS" if entering the grey tank, or "bLS" if entering the
black tank. When this occurs release both buttons.
Page 10
709-RVC Manual
Advertisement
Table of Contents
