Assembly; Installation Of The Start Unit To The Top Part Of The Handle; Installing The Handle - Fieldmann FZR 2021-E Manual

Hide thumbs Also See for FZR 2021-E:

Table of Contents

Available languages

Assembly

5. ASSEMBLY

For the purpose of transportation, the lawnmower is supplied disassembled. Before use, it must be assembled

according to the following steps:

Fig. 2.1

Place the start unit against the handle, see ﬁ gure 2. 1

Put on the bottom fastening part, see ﬁ gure 2.2

Join both parts together using the included screws and tighten appropriately. Figure 2.3

Fig. 3.1

Prior to installing the handle, slide the power cord holding hook on to the top part. Figure 3. 1

Connect the top and bottom part of the handle using the included screws and thumb nuts. Figure 3.2

Slide both handle ends into the holes in the body of the lawnmower and secure in place from the side using

the included screws. Figure 3.3

Attach the power cord to the handle using the plastic clips.

Note: the handle can be folded for storage purposes.

Fig. 2.2

Fig. 3.2

Fig. 2.3

Fig. 3.3

FZR 2021-E

Table of Contents

Table of Contents