Hyundai HP6700LN User Manual page 46

5. LOAD
Start appliances one-by-one.
5.1. 230 Volt AC use.
After switching ON the main breaker switch, and the engine running check the Voltage reading
5.1.1
when in 'Voltage Mode'. It should read 230v ± 5% (50Hz).
The Digital panel only becomes active when the Main breaker is in the 'ON' position.
5.1.2.
The following will be displayed by successive presses of the 'M' or mode button.
5.1.3. Connect the equipment to the generator in correct order.
5.1.4. Connecting the loads with the largest motor first, then the smaller items.
5.1.5. If the generator is overloaded the main breaker will trip.
5.1.6. To reset the breaker do the following;
5.1.6.1. Turn OFF and disconnect all loads.
5.1.6.2. Reset breaker, and add load onto the circuit to within 50% to 75% of rated output.
5.1.7. Wait a few minutes before resuming operation.
5.2. Electrical appliances, particularly motor driven equipment, will have a very high
start- up current. The table below provides reference for connecting these appliances to the generator.
Type
Starting
Lighting
x 1
Heating
Appliance
Fluorescent
x 2
Lamp
Motor
Driven x 3.5
Equipment
Wattage Typical
appliance
Rated
Incandescent
lamp or heating
x 1
appliance
Fluorescent
x 1 to x 1.5
x 1 to 2 Refrigerator,
Electric
Compressoror
grinder
ENGLISH
Lamp
Indicating
Illuminated
V
Hz
Frequency
Event timer - or current
running time (hours).
This will reset to zero
V1
when main Breaker is
V2 Total Run Time
Appliance
Incandescent
lamp 1000
watts
Fluorescent Lamp
Lamp
fan,
Refrigerator150
watts
17
51
Voltage
'OFF'
Example
Starting Rated
100 vA 100 vA
40 to 60
80 vA
vA
450 to 750 150 to 30
vA vA