Replacing Wheels - Toyota Land Cruiser 2006 Owner's Manual

NOTICE
If the wrong combination of tire and
chain is used, the chains could dam-
age the vehicle body.
CHAIN INSTALLATION
Install the chains on the rear tires as
tightly as possible. Do not use tire
chains on the front tires. Retighten
chains after driving 0.5 – 1.0 km (1/4 –
1/2 mile).
When installing chains on your tires, care-
fully follow the instructions of the chain
manufacturer.
If wheel covers are used, they will be
scratched by the chain band, so remove
the covers before putting on the chains.
CAUTION
D
Do not exceed 50 km/h (30 mph) or
the chain manufacturer's
mended speed limit, whichever is
lower.
D
Drive carefully avoiding
holes, and sharp turns, which may
cause the vehicle to bounce.
D
Avoid sharp turns or locked−wheel
braking, as use of chains may ad-
versely affect vehicle handling.
D
When driving with chains installed,
be sure to drive carefully. Slow
down before entering curves
avoid losing control of the vehicle.
Otherwise an accident may occur.

Replacing wheels

WHEN TO REPLACE YOUR WHEELS
If you have wheel damage such as
bending, cracks or heavy corrosion, the
wheel should be replaced.
recom-
If you fail to replace a damaged wheel,
the tire may slip off the wheel or cause
loss of handling control.
bumps,
WHEEL SELECTION
When replacing wheels, care should be
taken to ensure that the wheels are re-
placed by ones with the same load ca-
pacity, diameter, rim width, and offset.
Correct replacement wheels are available
at your Toyota dealer.
to A wheel of a different size or type may
adversely affect handling, wheel and bear-
ing life, brake cooling, speedometer/odom-
eter calibration, stopping ability, headlight
aim, bumper height, vehicle ground clear-
ance, and tire or snow chain clearance to
the body and chassis.
337