Connecting The Power Supply - Medion Nettop Manual

Connecting the Power Supply

Diagram reference: H
Finally, connect the power supply to your Nettop PC and monitor.
1. Plug the main connection cable into the plug socket and connect it with the main
cable connection (H) of your Nettop PC.
Observe the following safety precautions:
Please note
Even with the power switch switched off some parts of the device receive
current. You must unplug the power plug from the socket, if you want
to interrupt the power supply to your Nettop PC or cut off your device
from current entirely.
•
The power socket must be in the vicinity of the Nettop PC and within reach of the
power cables. Do not stretch the power cables tightly to reach a power socket.
•
Only operate the Nettop PC on grounded plugs of the domestic power net.
•
Use only the supplied power cord.
•
To provide additional protection against electric shock, power surges, lightning
strikes, or other electrical damage to your Nettop PC, we recommend the use of a
surge protector.
•
If you are using an extension cord, ensure that the cord meets your local safety re-
quirements. If in doubt, ask an electrician.
•
The power supply unit has an On/Off switch that can be used to power off the Net-
top PC. When the switch is Off (0) no power is being consumed.
First, read the following section to find out what you need to know in order to get started.
Do not start your Nettop PC yet!
Connecting
- 17 -