Connecting A Microphone; Connecting A Sound Source/Audio Input; Connecting Speakers/Audio Output; Nettop Pcs With Surround Sound - Medion Nettop Manual

Connecting a Microphone

Diagram reference: I
1. You can use the pink socket I to connect a microphone with a 3.5 mm mono jack
plug.
2. Position the microphone in such a way that it does not point directly at the speak-
ers. If you hear feedback, characterised by loud whistling noises, reposition the mi-
crophone until the sound stops.

Connecting a Sound Source/Audio Input

Diagram reference: J
This port is used to accommodate a connecting cable for external analogue audio
sources (i.e. stereo system, keyboard/synthesizer).
1. Connect the cable with the 3.5 mm stereo jack plug to the light-blue coloured
socket marked with

Connecting Speakers/Audio Output

Diagram reference: K
Here you can connect your active speakers for replaying or audio connection cables
for recording. Please refer to the user's guide of your stereo installation for information
about which connector you should use (usually Line In or Aux).
1. Connect the cable with the 3.5 mm stereo jack plug into the green socket marked
( )
( )
( )
with on the rear of your Nettop PC.

Nettop PCs with Surround Sound

Diagram reference: K
Connect your surround equipment as follows:
1. Connect the front speaker to the green socket marked with
2. Attach the rear loudspeakers to the connector REAR.
3. Your centre speaker or subwoofer can be connected to the socket
CENTER.
4. Connect to the optional SIDE socket two more speakers for the back surround.
( )
( )
( )
.
Connecting
( )
( )
( )
.
- 15 -