Connecting Usb Devices; Lan Connection - Medion Nettop Manual

Connecting USB Devices

Diagram reference: F
Warning!
Connect your USB devices after initial set-up of your new Nettop PC. This
will prevent unnecessary confusion during installation. These devices can
generally be connected during operation. Read the manual for your periph-
eral device first.
•
The voltage outputs of your Nettop PC for USB are protected by a fuse (limited
power source according to EN60950). This ensures that a malfunction of the Net-
top PC will not damage the peripheral devices connected to the respective jacks.
You have a choice of several connection sockets. It does not matter which you use.
Note
Take care that the connector and the socket fit exactly to avoid damaging
the contacts. Because of its asymmetric form the plug only fits into the
socket in one position.
1. If you wish to use a printer, scanner or other device with a USB port, connect the
cable to the USB socket on your Nettop PC.
Note
Connect your devices always to the same port otherwise your operating sys-
tem will give a new ID and asks for driver installation.

LAN Connection

Diagram reference: G
Your Nettop PC is equipped with a network connection, in order to prepare it for network
operation.
The network cable usually has two RJ45 plugs so that it is unimportant which plug is
connected to which jack.
1. Connect the one plug of the cable to the Nettop PC jack.
2. Connect the other plug to the other Nettop PC or hub/switch.
For further information refer to chapter "The Network" starting at page 36.
- 14 -
Connecting