Table of Contents
Advertisement
Tensioning the film
A-61058 January 2003
5. When a film leader has been generated (or you press the Stop
Advance key) the Film Advance screen will be redisplayed.
NOTES:
•
If you press the Film Supply key, the amount of the film
remaining in the upper and/or lower cassette will be displayed
on the screen as current units (English=feet; metric=meters).
The media supply indicators also display the amount of film
remaining in the cassettes as percentages. For example, 3
bars (|||) would indicate 30% of film remaining.
•
The Error symbol is only displayed when an error has been
posted to the Error Log. If the Error symbol is displayed, you
can view the message(s) not previously viewed by pressing
the Clear Message key. Up to the last ten messages can be
viewed on the screen by pressing the Clear Message key. If
there are more than ten messages, you can view the rest of
them via the Error Log screen. For more information, see the
section entitled "Viewing error messages" in this chapter.
You may advance the film using a fixed value of 1 inch (25 mm). To
do this:
1. Place the Writer in off-line mode.
2. Press the Film Control key. The following screen will be
displayed:
F
Film Control
Film
Supply
E
F
E
Film
Run To
Advance
End
Main
Menu
3-7
Advertisement
Table of Contents
