Riello UPS Netman208 Installation And User Manual page 91

The correct syntax for addAccessEntry is:
addAccessEntry
<contextMatch> <readView> <writeView> <notifyView>
<groupName> is the name of the group to which this access right applies, must match one
of the group name defined with addGroup.
<contextName> is the name of the context.
<securityModel> is the security model that must be used in order to gain access to this
access right, must match the security model defined with addGroup.
<securityType> is the minimum security level that must be used to gain access to this access
right. Possible values are:
noauthnopriv

 authnopriv (authentication but no privacy)
 authpriv (authentication and privacy)
<contextMatch> the type of match required. Possible values are:
exact (the context name must exactly match the value in contextName)

prefix (the context name must match the first few starting characters of the value in

contextName)
<readView> the authorized MIB view name used for read access, must match one of the
view name.
<writeView> the authorized MIB view name used for write access, must match one of the
view name.
<notifyView> the authorized MIB view name used for notify access, must match one of the
view name.
The correct syntax for addView is:
addView <viewName> <subtree> <mask> <included>
<viewName> is the name of the view.
<subtree> is the OID subtree which when combined with the corresponding instance of
MASK defines a family of view subtrees.
<mask> the mask for filtering OID.
<included> the OID can be included or excluded. Possible values are:
included (for including)

excluded (for excluding)

The correct syntax for addManager is:
addManager <security> <ipAddress> <credentials> <securityType>
<security> is the security type for the notification. Possible values are:
USM (User-based Security Model with SNMPv3)

 v2 (SNMPv2)
 v1 (SNMPv1)
<ipAddress> is the IP address of the SNMP manager.
<credentials> is either the username (when using USM security) or the trap community
(when using v1 security)
<securityType> is either:
noauthnopriv

 authpriv (for SNMPv3)
addManager do not allow duplicate entries (one ipAddress can receive only one trap).
<groupName> <contextName>
(no authentication and no privacy)
(for SNMPv1 and SNMPv2)
<securityModel>
- 91 -
<securityType>