Configuration - Riello UPS Netman208 Installation And User Manual

CONFIGURATION

Netman 208 can be configured via HTTP using the web browser interface.
Netman 208 is provided by default with the DHCP enabled.
Netman 208 requires approximately 2 minutes to become fully operational from when it
is powered up or following a reboot; before this time the device may not respond to
commands that are sent to it.
To configure the Netman 208, enter the IP address or the hostname into your web browser and then
log in with the following username and default password:
Username: admin
Password: admin
At the first boot or if you don't know the IP address, you can use the Zero Configuration Networking
(Zeroconf) as described below.
On the bottom side of the card, you can find the label reporting the mac address of your Netman
208.
Take note of the last six characters of the mac address.
00 02 63
63
In the address bar of a web browser, enter:
http://netman63XXYYZZ.local
replacing XXYYZZ with the last six characters of the mac address.
For example, if the mac address of your Netman 208 is 00:02:63:08:03:1f, you must enter
http://netman6308031f.local in the address bar of the web browser.
Then log in with the following username and default password:
Username: admin
Password: admin
For security reasons, we suggest the user changes the default password "admin" with a
secure password.
To make a new configuration active, it is necessary to save it. Some changes are applied
immediately, while others require a reboot of the Netman 208.
XX YY ZZ
- 15 -