Resetting A Device's Wireless Settings - Quell Q4000DCS-WCB User Manual

d. relAX And WAIt
Wait until the new device has connected to the network. Once connected,
the new device will speak, "Success now connected!"
•
Once connected, the light ring will glow green.
e. FInIsh AddIng neW deVIce - comPlete WIreless
netWorK setUP
Press and hold the button on the INSTALLED device for 5 SECONDS until you
hear two beeps. Release button. "Sonar" ping will stop.
•
Device will announce that setup is complete and the number of
connected devices.

7.3 Resetting a Device's Wireless Settings

If you encounter an issue at any point during the wireless network setup
process, you may reset the device by following the directions below.
A. begIn reset
Press and hold the button on the device for 8-9 seconds until you hear
3 beeps. Release button. You will hear the words "Resetting wireless settings."
b. conclUde reset
Light ring will flash green once and then it will pulse red. You will hear the
words, "Ready to connect, follow quick start instructions."
•
Device has been reset.
•
See Section 7.1 to begin set-up of a new wireless alarm network,
or Section 7.2 for adding this device to an existing alarm network.
note: If no further steps are taken within 15 minutes of
resetting the unit's wireless settings, a voice prompt "No devices found, not
connected" will be heard once, and the wireless function will turn off.
The unit will then perform as a stand alone alarm. See Section 7.2 for adding
this device to an existing alarm network.
"Success, now
connected!"
Figure 7.2-D
"Setup
complete!"
Installed Device
Figure 7.2-E
"Resetting
wireless
settings."
Figure 7.3-A
connect, follow
Quick Start
instructions."
Figure 7.3-B
Added Device
Hold for
8-9 seconds
"Ready to
13