Table of Contents
Advertisement
a
tof
djustiNg
PositioN
Use the following procedure to set TOF to accord with the reference
position (23.28 mm (11/12 in)). The reference position refers to the first
line of the paper i.e. the position to which the printer feeds the paper
when automatically loading the paper.
NOTE
Adjusting of TOF can be done in cut sheet mode or continuous
forms mode.
1.
Print out the menu settings of the printer as in
current settings" on page 47
sheet mode or continuous forms mode) is 23.28 mm (11/12 in).
2.
Set the Paper Type lever to the required paper type.
3.
When continuous forms are used, place the paper on the Pin
Tractor.
For cut sheet mode, do not insert the paper at this stage.
4.
In continuous forms mode, press the LOAD/EJECT button.
In cut sheet mode, place the paper in the Paper Tray and press
LOAD/EJECT.
5.
Press the following buttons to adjust the first printing line:
To feed the paper forward by a small amount, press and hold
down the LOAD/EJECT button and then press the SEL button.
To feed the paper backward by a small amount, press and hold
down the LOAD/EJECT button and then press the LF/FF button.
NOTE
If the specified correction range is more than +- 3.53 mm (20/144
in) for ML1120 and +- 4.23 mm (30/180 in) for ML1190, the paper
cannot be moved.
When the paper is positioned at the required TOF, release the
buttons in Step 5 above.
NOTE
Do not turn the Platen Knob or switch off the printer during the
above procedure.
ML1120/ML1190 User's Guide - Operating instructions > 65
and confirm that the TOF (in cut
"Confirming
Advertisement
Table of Contents
