Working Mode - ADF Web HD67931-B2 Series User Manual

Industrial Electronic Devices
S D :
ELECT EVICE
This section is used to select the converter in use. It is possible to define:
Only Ethernet Cable: MQTT is available on LAN port.
Ethernet Cable + Wi-Fi: MQTT is available on Wi-Fi and LAN port.
Ethernet Cable + Mobile
port.
W M :
ORKING ODE
This section is used to define the working mode of MQTT side of the converter. It is
possible to define:
Mode: on MQTT side, the data inside the payload of the messages
Standard
are already readable and coded in relation to the user definition.
Raw Mode: on MQTT side, it is possible to see the M-Bus responses in raw,
without any decoding.
M-B :
US
This section is used to define the main parameters of M-Bus line. The means of the
fields are:
In the field "M-Bus on
not;
In the field "Baudrate" the data rate of the M-Bus line is defined;
In the field "Parity" the parity of the M-Bus line is defined;
If the field "Cyclic Delay" the delay (expressed in seconds) between two M-
Bus scanning is defined;
In the field "Node State value when slave device is not
possible to insert the value to assign to the "Node State" when the Gateway
doesn't find the interrogated M-Bus slave;
If the field "M-Bus request only when MQTT is
converter reads M-Bus side only if MQTT is connected.
ADFweb.com S.r.l.
Connection: MQTT is available on LTE and LAN
Wire" it is possible to define if the port is present or
connected" is checked, the
User Manual M-Bus / M-Bus Wireless / MQTT
Document code: MN67931_ENG
Figure 3b: "Set Communication
Figure 3c: "Set Communication
present" it is
Figure 3d: "Set Communication
Revision 1.200 Page 20 of 49
 Select Device" window
 Working Mode" window
 M-Bus" window