Disposal Information - Flex SD 5-300 4.0 Original Operating Instructions

SD 5-300 4.0
Selecting the rotation direction
(see figure G)
For forward/tighten direction: Press the front
part of the forward/reverse switch (3).
For reverse/loosen direction: Press the rear
part of the forward/reverse switch (3).
Before use
■ Wear personal protective equipment (PPE).
Depending on the application, use face
shield, safety goggles or safety glasses.
As appropriate, wear dust mask, hearing
protectors and gloves.
■ Check the tool and its accessories for
damage. Do not use the tool if it is
damaged or worn out.
■ Check for loose screws, misalignment
or binding of moving parts, or any other
condition that may affect the operation. If
abnormal vibration or noise occurs, switch
the tool off immediately and have the
problem corrected before further use.
■ Charge the tool if needed. Do not use the
tool if it is bulging or hot.
■ Always firmly hold the tool by its handle.
Keep the tool clean.
■ Switch the tool off immediately if
bystanders are interrupting the work.
Never lay the tool down until the bit has
come to a complete stop. The spinning bit
may grab the surface and pull the tool out
of your control.
■ Do not work continuously for extensive
amounts of time with the tool. Take
breaks in between work to ensure full
concentration while using the tool.
Driving screw (see figure H)
■ Select and install a suitable bit.
■ Pressing on the desired direction of the
forward/reverse switch.
NOTE
Always hold the tool aligned to the fastener.
Holding it at an angle may cause slipping or
jamming of the fastener.
Maintenance and care
Cleaning
■ Clean the power tool regularly. Frequency
of cleaning is dependent on the material
and duration of use.
Spare parts and accessories
For other accessories, in particular tools
and polishing aids, see the manufacturer's
catalogues.
Exploded drawings and spare-part lists can
be found on our homepage:
www.flex-tools.com

Disposal information

WARNING!
Render redundant power tools unusable:
mains operated power tool by removing
the power cord,
battery operated power tool by removing
the battery.
EU countries only
Do not throw electric power tools into
the household waste!
In accordance with the European Directive
2012/19/EU on Waste Electrical and
Electronic Equipment and transposition into
national law used electric power tools must
be collected separately and recycled in an
environmentally friendly manner.
Raw material recovery instead of
waste disposal.
Device, accessories and packaging should
be recycled in an environmentally friendly
manner. Plastic parts are identified for
recycling according to material type.
WARNING!
Do not throw batteries into the household
waste, fire or water. Do not open used batteries.
EU countries only:
In accordance with Directive 2006/66/EC
defective or used batteries must be recycled.
NOTE
Please ask your dealer about disposal options!
13