Kubota L3302 Operator's Manual page 17

(1) SMV emblem
• Follow all local traffic and safety regulations.
• Turn the headlights on. Dim the headlights when
meeting another vehicle.
• Drive at speeds that allow you to keep control at all
times.
• Do not apply the differential lock while traveling at
road speeds. The tractor may run out of control.
• Avoid sudden motions of the steering wheel as they
can lead to a dangerous loss of stability. The risk is
especially great when the tractor is traveling at road
speeds.
• Keep the ROPS in the "UP" position and wear the
seat belt when driving the tractor on the road.
Otherwise, you will not be protected in the event of
a tractor roll-over.
• Do not operate an implement while the tractor is on
the road. Lock the 3-point hitch in the raised
position.
• When towing other equipment, use a safety chain
and set an SMV emblem on the equipment as well.
(1) Safety chain
• Set the 3-point hitch-lowering speed knob in the
"LOCK" position to hold the implement in the raised
position.
L3302,L3902
(2) Bracket
SAFE OPERATION
(1) 3-point hitch lowering speed
knob
PRECAUTIONS FOR PARKING
THE TRACTOR
• Disengage the PTO, lower all implements to the
ground, set all control levers in their "NEUTRAL"
positions, set the parking brake, stop the engine,
remove the key from the ignition, and lock the cab
door (if equipped).
Leaving transmission in gear with the engine
stopped will not prevent the tractor from rolling.
• Make sure that the tractor has come to a complete
stop before dismounting from it.
• Avoid parking on steep slopes. If possible, park on
a firm and level surface. If it is not possible to park
on a firm and level surface, park across a slope and
chock the wheels.
Failure to comply with this warning may allow the
tractor to move and could cause injury or death.
PRECAUTIONS FOR
OPERATING THE PTO
• Wait until all moving components have completely
stopped before getting off the tractor, connecting,
disconnecting, adjusting, cleaning, or servicing any
PTO-driven equipment.
• Keep the PTO-shaft cover in place at all times.
Replace the PTO-shaft cap when the shaft is not in
use.
(A) Fast
(B) Slow
(C) Lock
11