Kubota L3302 Operator's Manual page 124

PERIODIC SERVICE
2. After draining, reinstall the drain plugs.
(1) Drain plugs
(1) Drain plugs
3. Remove the hydraulic-oil filter.
4. Wipe off the metal filings from the magnetic filter
with a clean rag.
(1) Hydraulic oil filter
5. Put a film of clean transmission oil on the rubber
seal of the new hydraulic-oil filter.
6. Quickly tighten the hydraulic-oil filter until it contacts
the mounting surface, then tighten it by hand only
an additional 1/2 turn.
7. Fill with the new Kubota SUPER UDT fluid from the
oil inlet up to the upper notch on the dipstick.
118
(2) Magnetic filter (wipe off met-
al filings)
SERVICE EVERY 400 HOURS
(See LUBRICANTS, FUEL, AND COOLANT on
page 96.)
(1) Oil inlet
[Manual transmission type]
(1) Dipstick
[HST type]
(1) Dipstick
8. After operating the engine for a few minutes, stop
the engine and check the level of the transmission
oil again.
(A) Range that transmission oil
level is acceptable within
(A) Range that transmission oil
level is acceptable within
L3302,L3902