Clevo P170SM-A Service Manual page 47

Processor Installation Procedure
1. Insert the CPU , pay careful attention to the pin alignment
A
FORCE IT!), and turn the release latch
2. Remove the sticker (Figure
C
3. Insert the heat sink unit as indicated in
D
4. Tighten the CPU heat sink screws in the order
18d).
5. Replace the CPU fan, component bay cover and tighten the screws
a.
A
b.
B
(Figure
towards the lock symbol
B
18c) from the heat sink unit (if it is a new unit).
Figure 18c.
, &
, (the order as indicated on the label and
1 2 3 4
c.
C
D
d.
2 4
3 1
18a), it will fit only one way (DO NOT
(Figure 18b).
(page 2 - 21).
Note:
Tighten the screws in the order 1-2-
3-4 as indicated on the label.
Removing and Installing the Processor 2 - 23
Disassembly
Figure 18
Processor
Installation
a. Insert the CPU.
b. Turn the release latch to-
Figure
wards the lock symbol.
c. Remove the sticker from
the heat sink unit and in-
sert the heat sink.
d. Tighten the screws.

A. CPU
D. Heat Sink
• 4 Screws