Table of Contents
Advertisement
Available languages
Available languages
Assembly instructions
p. 8/8
Fit the tensioning straps.
Note that the tension rods are placed in the lower half of the barrel sauna.
Before tensioning the metal bands, remove the screws from the staves. Tighten
the metal bands so that there is no visible gap between the staves. This must
be checked regularly and retightened if necessary.
2.5. Mounting the door
Place the door frame in the opening from the outside. Note that the door opens
outwards —the door can be attached on the left or on the right.
Fix the door from the inside with the cover slats.
The door handles are screwed from the inside.
2.6. Installing interior fittings
Place the floor grid so that it is level.
Fit the bench support slats at a height of approx. 45 cm to the floor grid.
Install the benches and screw them to the barrel staves.
Fix the backrests approx. 20 cm above the bench.
2.7. Installing outside beches
Assemble the support feet to the benches.
Fit the bench support slats at a height of approx. 52 cm to the bottom stave.
Place the benches on the bench support slats and screw the feet.
2.8. Installing accessories
Fit the ventilation panel on the inside.
For the lighting fit the metal clips on the wooden strip. Clamp the LED strip and
drill the cable bushing at the desired location (the power supply unit may be
placed outside the sauna).
Assemble the protection grille.
Fit the insect screen on the outside.
2.9. Covering the roof
Install the triangular strips (drip edge) at a height of approx. 116 cm.
Start attaching the bitumen shingles on the triangular strip with the top of shingle
sheets facing down. Now lay the other shingle sheets overlapping and evenly
offset. You can make the top ridge row from sections. These are laid overlapping
in a scale-like manner. Pay attention to the prevailing wind direction.
The mounting strips on the inner walls can now be removed.
Advertisement
Chapters
Table of Contents
