Trailering - TOHATSU M 15D2 Owner's Manual

ENON00021-3
Note
If the outboard motor must be laid down,
be sure that fuel is completely drained,
then lay the outboard motor with port side
down on the cushion as shown in the
drawing.
1. Handle
ENOM00072-A

3. Trailering

ENOW00072-0
CAUTION
Trailering in the tilted position may cause
damage to the outboard motor, boat, etc.
ENOW00073-A
WARNING
Be sure to disconnect fuel connector except
when operating engine.
REMOVING AND CARRYING THE OUTBOARD MOTOR
Fuel leakage is a fire or explosion hazard,
which can cause serious injury or death.
ENOW00068-0
Close air vent screw on fuel tank and fuel
cock before carrying or storing outboard
ENOF01738-0
motor and fuel tank, or fuel may leak, poten-
tially catching fire.
ENOW00071-0
The tilt support device supplied on your out-
board motor is not intended for towing. It is
intended to support the outboard motor
while the boat is docked, beached, etc.
When transporting a boat on a trailer
with the outboard motor attached, dis-
connect the fuel line from the outboard
1
motor beforehand and keep the out-
board motor in the vertical position or on
ENOF01728-0
a transom saver bar.
Tiller handle type
While transpor ting outboard motor
attached to the boat on a trailer, properly
tighten the steering friction bolt to pre-
vent the outboard motor from moving
(page 51).
ENOF00075-1
WARNING
CAUTION
49
8