Trailering - TOHATSU M 4C Owner's Manual

ENON00021-3
Note
If the outboard motor must be laid down,
be sure that fuel is completely drained,
then lay the outboard motor with port side
down on the cushion as shown in the
drawing.
ENOM00072-1A

3. Trailering

ENOW00072-0
CAUTION
Trailering in the tilted position may cause
damage to the outboard motor, boat, etc.
ENOW00073-A
WARNING
Be sure to disconnect fuel connector except
when operating engine.
Fuel leakage is a fire or explosion hazard,
which can cause serious injury or death.
REMOVING AND CARRYING THE OUTBOARD MOTOR
ENOW00068-1
Close air vent screw on fuel tank and fuel
cock before carrying or storing outboard
motor and/or fuel tank, or fuel may leak,
potentially catching fire.
ENOF02131-0
ENOW00071-0
The tilt support device supplied on your out-
board motor is not intended for towing. It is
intended to support the outboard motor
while the boat is docked, beached, etc.
ENOW00072-A
When trailering the outboard motor should
be in a vertical (normal running) position,
ENOF02132-0
fully down. Trailering in the tilted position
may cause damage to the outboard motor,
boat, etc.
If trailering with outboard motor fully down
is not available (the gear case skeg is too
close to the road in a vertical position), fix
the outboard motor securely using a device
(like a transom saver bar) in the tilted posi-
tion.
ENOF00075-1
WARNING
CAUTION
CAUTION
41
8