Table of Contents
Advertisement
46
ENGINE OPERATION
ENOM00063-1
Tilt down
Pull the reverse lock lever upward until it
comes to a stop (This is the tilt down
position), lift up the outboard motor to
free it from the reverse lock, then release
to lower the outboard motor.
3
1. Reverse lock lever
2. Tilt up position
7
3. Tilt down position
ENOM00068-A
9. Shallow water operation
ENOW00051-0
During shallow water operation, be careful
not to place your hand between the swivel
bracket and the clamp bracket. Be sure to
tilt the outboard motor down slowly.
ENOW00053-0
While in shallow water drive position, do not
operate the outboard motor in Reverse.
Operate the outboard motor at slow speed
and keep the cooling water intake sub-
merged.
1
2
ENOF01725-0
WARNING
CAUTION
ENOW00054-1
CAUTION
Do not over tilt the outboard motor when
driving in shallow water, or air may be sucked
through water inlet and sub-water inlet,
potentially leading to engine overheating.
2
1. Water inlet
2. Sub-water inlet
1. Shallow water running position:
Put the reverse lock lever in the tilt up
position, and tilt up the outboard
motor to put the outboard motor in
the shallow water running position.
3
2
1. Reverse lock lever
2. Tilt up position
3. Tilt down position
2. Return to normal running position:
Put the reverse lock lever in the tilt
down position, slightly lift up the out-
board motor, and then put it down.
1
ENOF01144-0
1
ENOF01725-0
Advertisement
Table of Contents
