Table of Contents
Advertisement
5. Remove fuel and any water or debris
from the cup, filter and hoses.
6. Reassemble all parts.
ENOM00096-A
Fuel filter (for fuel tank)
1. Remove four screws to detach the
Fuel Pick-Up.
2. Clean the fuel filter and replace the
gasket.
3. Reassemble all parts.
1. Fuel pick-up
2. Filter
ENOM00098-1A
Gear oil replacement
ENOW00076-1
WARNING
Be sure that the outboard motor is
secured to transom or service stand, or
accidental drop or fall of outboard motor
could lead to severe personal injury.
Be sure to lock the outboard motor in the
tilt up position, or accidental fall of out-
board motor could lead to severe per-
sonal injury.
Do not go under outboard motor in the tilt
up position and locked, or accidental fall
of outboard motor could lead to severe
personal injury.
ENON00934-1
Note
Dispose used oil according to the local
regulation. For oil disposal, we suggest take
it into local service station in a sealed con-
tainer. Do not throw the used oil in trash,
pour it on the ground or down a drain.
1. Tilt down the outboard motor.
2. Remove the oil plugs (lower and
1
2
ENOF00926-1
3. Insert the oil tube nozzle into the
ENON00033-1
Note
Use genuine gear oil or the ones recom-
mended (API GL-5: SAE #80 to #90).
INSPECTION AND MAINTENANCE
upper), and completely drain the gear
oil into a pan.
lower oil plug hole and fill with gear oil
by squeezing the oil tube until oil
flows out of the upper plug hole. Make
sure that no bubbles are coming out
of the upper plug hole and there is no
air inside the gear case.
61
10
ENOF01732-0
Advertisement
Table of Contents
