Route The Cables; Connect The Cables And Attach Unit Casing To Mounting Bracket - Axis Q3505-V Installation Manual

AXIS Q3505–V Fixed Dome Network Camera

Route the Cables

Note
See Hardware Overview on page 10.
Depending on whether you want to route the cables through or along the wall, follow the relevant
instructions below. To route cables through the wall:
1. Using the drill template drill 4 holes for mounting the bracket, and one or two holes as
required for routing the cable or cables in the wall.
2. Route the network cable (and the multicable if required) through the wall and through
the hole or holes in the mounting bracket.
The cables can be routed along the wall in one of the following ways:
1. Through the side hole in the mounting bracket. To do this detach the locking clip and
side lid in the mounting bracket. Use an appropriate conduit adaptor as required (see
www.axis.com for optional accessories). See Hardware Overview on page 10.
2. Through the side lid after drilling a hole in the lid for the cable. Replace the side lid and
clamp down the locking clip to hold it in place.

Connect the Cables and Attach Unit Casing to Mounting Bracket

1. Insert the SD memory card in the camera unit (optional).
2. Push the network cable through the black cable gasket in one of the holes in the unit
casing, using the connector guard provided. Pull the network cable back slightly so that
the cable gasket adjusts itself on the cable.
NO TICE TICE
NO NO TICE
Not pulling the cable back could cause water to seep in and damage the product.
It is recommended to route the cable through the hole farthest from the network connector
in the camera unit (see image below).
18