Table of Contents
Advertisement
3. Installation
3.6 UPS connection
HPE R/T2200 G4 NA/JP UPS
Check that the specifications on the rear UPS name plate correspond to the AC power source and the true electrical
consumption of the total load.
The UPS charges the battery as soon as it is connected to the AC power source, even if the
pressed.
After the UPS is connected to the AC power source, eight hours of charging is required before the battery can
supply the rated backup time.
HPE R/T3000 G4 LV NA/JP
Check that the indications on the name plate located on the back of the UPS correspond to the AC-power source and
the true electrical consumption of the total load.
The UPS charges the battery as soon as it is connected to the AC power source, even if the
pressed.
After the UPS is connected to the AC power source, eight hours of charging is required before the battery can
supply the rated backup time.
Page 20
8
9
10
8a
8b
11
1. Connect the UPS input plug
power source.
2. Connect the protected equipment to the
UPS.
It is preferable to connect the
critical loads to the 'Primary'
outlet group
and the non-critical loads
9
to either the Group 1 or Group 2 outlets
. Group 1 and Group 2 outlets can be
8
programmed to shed loads as desired.
3. To optimize the available backup time,
user the IN/OUT serttings to program
shutdown of outlets
during operation
8
on battery power (see "2.4 User settings"
on page 10).
button is not
10
1. Connect the UPS input plug
AC-power source.
2. Connect the loads to the UPS. It is prefer-
able to connect the critical loads to the
'Primary' outlet group shown as
the non-critical loads to either the Group
1 or Group 2 outlets shown as 8a and
8b. Group 1 and Group 2 outlets can be
programmed to shed loads as desired.
Connect any high-power device to the 30
A outlet
7
.
3. To optimize the available backup time,
use the in/out settings to program shut-
8
down of outlets
during operation on
battery power.
button is not
to the AC
10
to the
9
and
792519-001 Edition 2
Advertisement
Table of Contents
