Preparing To Use Your Maxi-Miser® Turbo System; Setting Up Your Pbc-Gto™ Spray Gun - Apollo Sprayers Maxi-Miser 3000 PRO Instruction Manual

5. Preparing to Use Your Maxi-Miser® Turbo System
Connect the male end of the air hose to the turbo system. Pull back the
spring loaded quick disconnect coupler and insert the male connector on
the air hose into the turbine connector. Release the ring. Your air hose
will be locked into place. To release the air hose, pull back on the spring-
loaded quick coupler ring with your fingers and pull.
Plug the power cord into a single phase 240 volt outlet that is properly installed and grounded in accordance with local
codes and ordinances. Your Maxi-Miser® system is rated for 240 volts. Plugging the turbo system into the wrong
voltage will damage the motor and void your warranty.
NOTICE!
Do not cover or enclose the turbine. It is important to draw cool/ambient air through the unit for optimum
performance. Avoid placing the turbine in a warm environment or in direct sunlight. Do not spray in ambient
temperatures above 90 degrees. If you want to be able to spray in hotter temperatures, we recommend placing
a fan in front of your turbine to help it pull in cool air or place it in an air conditioned environment.
6. Setting up Your PBC-GTO Spray Guns
Good quality results with your TrueHVLP™ spray finishing equipment are a combination of careful preparation of your
project, a proper spraying environment, a basic knowledge of the coatings you will be using and how these coatings
work with your Maxi-Miser™ finishing equipment.
Your PBC-GTO spray guns come with a 600cc gravity feed cup assembly standard. Some minor assembly is required:
1. Screw the cup to the material connector on the top of the spray gun
body. Tighten with (spanner) wrench only as shown in the "correct"
picture.
Page | 5
Connect female end of air hose to your spray gun using this same procedure.