Apollo Sprayers Maxi-Miser 3000 PRO Instruction Manual page 14

8.
Insert the air cap seal (#4). To insert, observe both sides of the seal. One side should
have three small circles. This side goes toward the spray gun. Snap the air cap seal onto
the air distributor (#6).
9. Push the needle (#21) back into the spray gun.
10. Insert the Needle Spring into the Material Adjustment Screw (#19).
11. Install the Material Adjustment Screw with Needle Spring (#20).
12.
Install air cap and air cap ring. Spray gun is now re-assembled and ready to use.
NOTE:
Periodically, use Apollo lubricant to lubricate the air valve bushing as
shown.
Pressure will remain in the spray cup when the unit is off. If you pull the
trigger back, a stream of fluid will flow. To prevent accidents, turn material
flow screw clockwise until it is completely closed. The trigger is now locked
in the closed position.
To relief the cup pressure prior to opening the cup use the twist connector located between the check
valve and the cup lid. Undo the connector and the air pressure will exhaust through the tube. If you
don't relieve the air pressure prior to opening the lid on the cup, paint can fly out and down the side of
the cup.
Page | 12