Advanced Network - D-Link DIR-809 User Manual

Section 3 - Configuration
Click Advanced Network on the navigation menu to configure the Advanced Wireless
settings. This page allows for the configuration of miscillaneous settings. When you are
satisfied with your configuration, click Save Settings.
Enable UPnP IGD: Click Enable to use the UPnP feature. UPnP provides compatibility
with networking equipment, software, and peripherals.
Enable WAN Ping Enable or disable the router to reply to pings.
Response:
WAN Port Speed: You may set the port speed of the Internet port to 10 Mbps, 100 Mbps,
or Auto 10/100Mbps. Using Auto 10/100Mbps is recommended.
Enable Multicast Enable to allow IPv4 multicast traffic to pass through the router from
Streams: the Internet.
IPV6 MULTICAST STREAMS
Enable IPv6
Enable to allow IPv6 multicast traffic to pass through the router from
Multicast Streams:
the Internet.
Click the Save Settings button when you are finished.
D-Link DIR-809 User Manual

Advanced Network

UPNP
WAN PING
WAN PORT SPEED
MULTICAST STREAMS
DIR-809
ADVANCED NETWORK ADVANCED NETWORK SETTINGS
ADVANCED NETWORK SETTINGS
These options are for users that wish to change the LAN settings. We do not recommend changing these settings from factory default.
Changing these settings may affect the behavior of your network.
Save Settings Don't Save Settings
UPNP
Universal Plug and Play(UPnP) supports peer-to-peer Plug and Play functionality for network devices.
Enable UPnP IGD :
WAN PING
If you enable this feature, the WAN port of your router will respond to ping requests from the Internet that are sent to the WAN IP
Address.
Enable WAN Ping Response :
WAN PORT SPEED
WAN Port Speed :
Auto 10/100Mbps
MULTICAST STREAMS
Enable Multicast Streams :
IPV6 MULTICAST STREAMS
Enable IPv6 Multicast Streams :
Save Settings Don't Save Settings
ADVANCED
▼
103